Home >>
1/4-inch Shank Chamfer Router Bits with 45 Degree 7/8-inch Cutting Length Tungsten Carbide Tipped
Description:
- Professional Quality Router Bits.
- Featured with tungsten carbide tip and 45 steel shank.
- For processing soft wood, hard wood, MDF, plywood, etc.
- Used to create a uniform chamfer on the edge of work piece to add character, while retaining crisp geometric lines.
- Chamfer size can be easily adjusted by changing the height of the bit.
- Use on hand held and table mounted portable routers.
- Standard: 1/4-inch x 7/8-inch
- Cutting Length: 7/8-inch
- Shank Diameter: 1/4-inch
- Cutting Angle: 45 Degree
- Cutting Diameter: 44.4mm / 1-3/4-inch
- Overall Length: 62.5mm / 2.46-inch
- Bearing Diameter: 1/2-inch
- Tip Material: Tungsten Carbide
- Shank Material: 45# Steel
- Flute Number: 2
- Suggested Rotation Speed: 18000-20000/Min
- Suggested Feed Speed: 200-300cm/Min
- Weight: 83g; Color: Beige,Silver Tone
- Package Content: 1 x Chamfer Bit
- Tool maintenance: Keep tools clean after using them, remove resin, sawdust on the timber, using standard industrial solvent to clean the tool.
- Apply a small amount of oil can prevent the tool surface rust, clean up all the dirt of the shank to prevent slippage during use.
- Do not attempt to grind the tool or change the shape of the tool.
- Notice: When the tool is blunt, replace with a new tool, do not continue to use the tool in order to avoid breakage.
- Must use a suitable clamp(not included here). If the clamp is not round or worn, it will cause the clamp can not clamp the tool properly, please replace the clamp with standard specification immediately to prevent dangerous situation such as handle shaking, flying off or twisted off when the tool is working at high speed.