|
Set the output of each flash by hand and confirm the results, either through using a handheld flash meter or by examining the output on-screen if you're using a digital camera.
Description: - The Wireless Flash Trigger is a radio remote system for firing hotshoe or PC-connected flash units wirelessly.
- Camera Tigger Control consists of a transmitter/receiver pair housed in inexpensive black plastic enclosures.
- Each unit is about the size of a small box of matches.
- The transmitter fits into a camera’s hotshoe and the receiver clips onto the hotshoe base of a battery-powered flash unit.
- Operation is very simple. Turn the receiver on by sliding over the power switch, and then take a photo. That’s it. A radio signal is transmitted from the transmitter to the receiver that instructs the flash to fire.
- Maximum effective area of the Radio-based Flash Trigger: 30m
- Total weight: 114.5g
Transmitter: - The transmitter also has a red LED that illuminates when a shot is taken, a small test pushbutton for test firing, a DIP switch block with two switches and a 2.5mm phono socket.
- Since the switch block has two switches with two positions each, a total of 4 digitally encoded signals are possible. The receiver will only trigger if both devices are set to the same code.
- Radio working frequency: 433MHz
- Size: 6 x 4 x 1.4cm
Receiver: - The receiver is a small rectangular plastic box with a chamfered top.
- It has a hotshoe mount for attaching a standard battery-powered hotshoe flash unit, and an extruded aluminium L bracket screwed to the side which can be used for attaching the trigger and flash to a stand or tripod.
- The black-painted L bracket, which can be rotated to tilt the flash, is fastened to the box with a plastic-handled bolt.
- It also has a 1/4-20 hole for screwing the unit to a tripod via a normal mounting stud, and has grooves in its foot so it can fit into another shoe bracket.
- This lets you slide the receiver into an umbrella mounting bracket designed to accommodate a hotshoe flash.
- The receiver is apparently designed to work with a sync (trigger) voltage of 3 volts or less
- This unit powered by 2AAA battery(not included)
- Size: 8.4 x 3.7 x 2.3cm
Pacakge contents: - 1 x Transmitter
- 1 x Receiver
This product was added to our catalog on Monday 28 July, 2008.
|
[4 of 5 Stars!]
