2pcs Plastic Battery Holder Case w ON/OFF Switch for 2 x 1.5V AA Batteries

Introductions:
A battery holder is one or more compartments or chambers for holding a battery. For dry cells, the holder must also make electrical contact with the battery terminals. For wet cells, cables are often connected to the battery terminals, as is found in automobiles or emergency lighting equipment. Where the battery is expected to last over the life of the product, no holder is necessary, and a tab welded to the battery terminals can be directly soldered to a printed circuit board. A good choice for you!

Features:

• Brand new and .
• Battery holder with cover and ON/OFF switch.
• Battery type: 2 pcs x 1.5V AA Case Holder.
• AA Battery Holder Case with 6inch leads for soldering / connecting.
• Takes 2 standard size AA batteries side by side to form a compact battery of rechargeables.
• Keep your batteries organized and protected.

Note: Please do not separate, maintain, or refit the product.The wires are thin, and the structure of this product is only fit for very small current load, DO NOT connect it to a load that will cause large current, stop using this product if the wires are hot.
1. When the battery case is working, the maximum power should be less than 5W, the working current should be less than 2A.
2.Please pay attention to your battery heat generation while using this product and do not use the poor quality battery.

Country of Manufacture	CHINA
Brand	Uxcell
Material	Plastic & Metal
Net Weight	45g
Package Content	2 x Battery Holder
Main Color	Black
Fit for	2 x 1.5V AA Batteris
Wire Length	15cm/ 6inch
Total Size	6.8 x 3.3 x 1.8cm/2.7 x 1.3 x 0.7inch(L*W*H)
MPN	Does Not Apply